A 1532 XA EVSE adapter Featured

eMobility

The A 1532 EVSE XA adapter is used for verification of electrical safety and functional testing of EVSE together with supported METREL installation testers. It is intended for testing Mode 3 EV supply equipment with a type 2 connector. XA version supports 3 phase load testing up to 13 A and different error types, including PE open. If used together with Metrel AutoSequences®, prebuilt in the newer multifunctional testers, the complete EVSE charging station can be tested (state-by-state) electrically and functionally with a push of a button. It is possible to create a professional station-based report with MESM.

Select a set

Standards applied

Building LV Installation

  • EISinsp Competences: Low Voltage Electrical Installation Safety Inspection
  • EISc Competences: Low Voltage Electrical Installation Safety for Contractors and Maintainers
  • IEC/EN 61557 Electrical safety in low voltage distribution systems up to 1 000 V AC and 1 500 V DC - Equipment for testing, measuring or monitoring of protective measures - series

Mobile Units Electrical Safety

  • ISO 6469-3 - Electrically propelled road vehicles Safety specification Part 3: Electrical safety

Electrical Vehicle Supply Equipment

  • EVSE Competences: Electrical Vehicle Supply Equipment Safety

Properties

Key features

  • Banana socket outputs for connection to a 3-phase installation tester;
  • Voltage indicators on EVSE output;
  • Proximity Pilot resistance selector for simulation of EV cable presence and current rating detection;
  • Control Pilot resistance selector for simulation of electric vehicle status;
  • Socket output for connection to a 1-phase installation tester (Phase 1, Neutral, PE);
  • Type 2 Male Plug connector for connection to EVSE;
  • 6 mA EV RCD support;
  • Functional tests support;*
  • EVSE AUTO SEQUENCE® support;*
  • MESM report creation;**
  • Load testing up to 13 A on socket - 1 phase or on banana sockets - 3 phase;
  • Fault simulation of Diode short, PE-CP short and PE open;
  • Output BNC connector for CP signal monitoring.

* Functional tests and AUTO SEQUENCE® are supported only on the MI 3155 Eurotest XD, MI 3152 EurotestXC and MI 3152 H EurotestXC 2.5 kV testers.
** Report printing is only available via the MESM PC SW. The MESM license (P 1101) is to be purchased separately.

Technical data

  • Dimensions (w x h x l): 200 x 100 x 70 mm
  • Mass (without accessories): 0.90 kg

Applications

e-Mobility

  • EVSE domestic installation testing
  • EVSE periodic inspection
  • Renewable power and car charging

Mobile installations

  • Vehicles with an on-board generator

Specifications

Downloads

Datasheet Language Version Release Notes Type Size Download
A 1532 XA EVSE adapter en 2020 10.11.2020 pdf 1.33 MB
Manual Language Version Release Notes Type Size Download
A 1532 XA EVSE adapter en 1.2.3 09.08.2021 20 753 114 pdf 525.58 KB Login
A 1532 XA EVSE adapter Multi-Language 2023 20.01.2023 zip 506.92 KB Login

Where to buy?

Search for distributors and partners

Have a question?

Speak with a specialist